RadarCarve stock Duplicator Sold
-
Ghostofwar
- AA Poster
- Posts: 313
- Joined: Fri Jul 18, 2008 11:20 am
- Location: Aiken, SC
RadarCarve stock Duplicator Sold
Sold
Buy this and duplicate some Pharr stocks!!!
I have a stock duplicator from RADARCARVE that I need to sell. Its new and has never been used or even assembled. I bought it about 2 years ago when I got laid off and was planning on starting to make stocks part time. Fortunately for me, I was not unemployed for long, but I never got around to using the duplicator either.
It is the Model One and uses the Bosch Colt router (not included in price but I do have one). The duplicator alone cost 1200 new and I am asking half that price.
I also have some laminate and walnut stock blanks from Boyds as well as a pile of rough cut and dried walnut, roughly 36x7x3 for all the walnut blanks. The walnut is mostly straight grain. Asking 400 for the Boyds blanks and the Walnut.
Pick up only, no shipping unless we work something out. I would be willing to bring this to Winnsboro for a pickup at the Southern Nationals.
Email me if you have any questions. DanielJWood47 (at) yahoo.com
Buy this and duplicate some Pharr stocks!!!
I have a stock duplicator from RADARCARVE that I need to sell. Its new and has never been used or even assembled. I bought it about 2 years ago when I got laid off and was planning on starting to make stocks part time. Fortunately for me, I was not unemployed for long, but I never got around to using the duplicator either.
It is the Model One and uses the Bosch Colt router (not included in price but I do have one). The duplicator alone cost 1200 new and I am asking half that price.
I also have some laminate and walnut stock blanks from Boyds as well as a pile of rough cut and dried walnut, roughly 36x7x3 for all the walnut blanks. The walnut is mostly straight grain. Asking 400 for the Boyds blanks and the Walnut.
Pick up only, no shipping unless we work something out. I would be willing to bring this to Winnsboro for a pickup at the Southern Nationals.
Email me if you have any questions. DanielJWood47 (at) yahoo.com
Last edited by Ghostofwar on Mon Jun 02, 2014 6:00 am, edited 1 time in total.
-
390jack
- B Poster
- Posts: 19
- Joined: Wed Feb 04, 2009 5:35 pm
- Location: PA
Re: RadarCarve stock Duplicator
email sent