Action Screws

High Speed · Post by **High Speed** » Fri Jul 19, 2013 2:42 pm

What is a good starting point for the Torque, in inch lbs for the action screws on a 54.18 in Pharr stock?
Thanks

Bob259 · Post by **Bob259** » Fri Jul 19, 2013 3:09 pm

I use 4.5 Nm with my Anschutz torque wrench

High Speed · Post by **High Speed** » Sat Jul 20, 2013 6:44 am

Thank you sir. I wish I had an Anschutz torque wrench. The only one I have measures in Inch pounds. Have any idea what that equates to?

cedestech · Post by **cedestech** » Sat Jul 20, 2013 6:55 am

http://www.unitconversion.org/unit_conv ... nergy.html

It's right at 40. I'd start about half that but that is just me. My factory and pillared Pharr I run at 20 inch pounds and they shoot lights out.

YMMV.

High Speed · Post by **High Speed** » Sat Jul 20, 2013 7:18 am

Thank you. I was pimping my ride, as it where. Was putting it back together, got to wondering about the torque on the actions screws. I was reading Kitty's post the other day about how sensitive some can be. Mine isn't shooting quite as good as I think it can at Rams. Shoots pretty much one hole + at 50 with rifle match. Thought I might play with the tension some. See if I could get it a little better way out there. Thanks for you info.
Stay Safe
Mark

High Speed · Post by **High Speed** » Sat Jul 20, 2013 7:40 am

That's a helpful site. Thanks for passing it along!
Stay Safe
Mark

Action Screws

Action Screws

Re: Action Screws

Re: Action Screws

Re: Action Screws

Re: Action Screws

Re: Action Screws