CZ 452 Silhouette

[ppkny]

Has anyone removed the butt plate from a CZ 452 silhouette with the synthetic stock.
ppkny

[daisy]

I looked at removing the old one and putting in a spacer, but slipped a slide recoil pad over it for a bit longer length of pull. I'm happy with it.

Daisy

[Dee]

I used the slip on pad also as well as one of those slip on Bearcreek adjustable neopreem/foam comb raising kits. The comb raising really helped a lot with the skinny somewhat straight comb on the sythetic factory stock. You can put a nice rise in it with the kit and its not cold to your face in the winter. Plus if you skip shaving for a couple of days your stubble will really anchor your cheek weld to the neopreem skin over the pad


Dee

[ppkny]

Dee, where did you get the adjustable cheek piece.
Thanks, ppkny

[daisy]

Dee, where did you get the adjustable cheek piece.
Thanks, ppkny

I had to have a search http://www.brownells.com/.aspx/pid=2087 ... ISING_KITS

[Dee]

I think I picked it up at Cabelas one day after a match. They sell for around $20 at most places online as well.


Dee

[ppkny]

On the advice of CZ-USA I used a heat gun to remove the butt plate on my CZ-452 Silhouette and it came off in seconds.
ppnky

[BCloninger]

Good to know! Thanks!

[Bob259]

On the advice of CZ-USA I used a heat gun to remove the butt plate on my CZ-452 Silhouette and it came off in seconds.
ppnky
[Picture removed]

We're in trouble now... I told you the band saw would have fixed it also. Can the pad mounting studs be reused or are they part of the stock?