rifle stock rule question

This is what we do.
Post Reply
pistolero45
A Poster
A Poster
Posts: 226
Joined: Tue Mar 20, 2007 4:15 pm
Location: Columbia, Missouri

rifle stock rule question

Post by pistolero45 »

Just for fun this winter, I've decided to build my own silhouette stock. So I have been reading the rule book, and have a question for you experts.

This question regards rule 3.1 (d), which reads in part, "the comb shall not extend above the centerline of the bore, but Monte Carlo roll may rise 1/2 inch on the off side."

So do I understand correctly, that the Monte Carlo roll can be 1/2 inch above the centerline of the bore? And for us right handed shooters, would this Monte Carlo roll be on the right side of the stock?

Thanks.
Mark
Boyd L.
AA Poster
AA Poster
Posts: 317
Joined: Sun Mar 08, 2009 5:42 pm

Re: rifle stock rule question

Post by Boyd L. »

I'm certainly no expert, but I've had a couple stocks made. It's my understanding that the "offside" comb that rises above the boreline, would be the opposite side of the shooter's "handedness". But no part of the comb may be directly in line with the bore.
User avatar
Jason
Uber Master Poster
Uber Master Poster
Posts: 3002
Joined: Tue Feb 28, 2006 7:36 pm
Location: Snohomish, WA

Re: rifle stock rule question

Post by Jason »

As I understand it, no comb above the centerline of the bore at the boreline, but may rise up to 1/2" above center of boreline on the side that the shooter's cheek is not on.
User avatar
Evelio Mc Donald
Sponsor
Sponsor
Posts: 779
Joined: Thu Feb 23, 2006 9:05 pm
Location: Wimberley, Texas

Re: rifle stock rule question

Post by Evelio Mc Donald »

As long as you can see clear daylight thru the bore,( over half the bore ) any roll over is legal. No groove clearance in the comb allowed.
Evelio.
Evelio
pistolero45
A Poster
A Poster
Posts: 226
Joined: Tue Mar 20, 2007 4:15 pm
Location: Columbia, Missouri

Re: rifle stock rule question

Post by pistolero45 »

Thanks for the good information.
Mark
TOP PREDATOR
A Poster
A Poster
Posts: 231
Joined: Sun Jun 28, 2009 5:05 pm
Location: N.E. PENNSYLVANIA
Contact:

Re: rifle stock rule question

Post by TOP PREDATOR »

related question:

what is the ruling if you have an adjustable cheekpiece?
"a craftsman can't realize his full potential, without finding the potential of the tools he uses...."
User avatar
Jason
Uber Master Poster
Uber Master Poster
Posts: 3002
Joined: Tue Feb 28, 2006 7:36 pm
Location: Snohomish, WA

Re: rifle stock rule question

Post by Jason »

You can check the rules yourself with the NRA rulebooks online here:

http://www.nrahq.org/compete/nra-rule-books.asp

There are lots of places where there's gray area that's going to be up to interpretation by the match director, though. For instance, here's the rule for adjustable cheekpieces in the silhouette rifle rulebook.
3.15 Buttplates and Cheekpieces - A butt or buttplate having a curved rear surface in which the depth of the curve exceeds 1/2 inch when measured from a straight line drawn from the top to the bottom of the buttplate is prohibited. buttplates must be centered. Adjustable cheek pieces must be fixed and sealed in place. See 3.4(f) regarding Black Powder Cartridge Rifle. Rule 3.15 does not apply to Target or Open class Air Rifles.
I would interpret that as adjustable cheekpieces being allowed as long as they are fixed and sealed in place. What it takes to "seal" it might be anything from duct tape to epoxy, depending on who's interpreting it. My guess, and it's only a guess, is that an adjustable cheekpiece would not be allowed in hunter class because that would violate the hunting style stock stipulation. That would be up the match director.
User avatar
BlauBear
Uber Master Poster
Uber Master Poster
Posts: 2734
Joined: Fri Jul 07, 2006 10:43 am
Location: Fort Smith, AR

Re: rifle stock rule question

Post by BlauBear »

I wouldn't travel to a match with an adjustable cheek piece and expect to shoot no matter how it was fixed in place.
"If the America people ever allow private banks to control the issuance of their currencies, first by inflation and then by deflation, the banks and corporations that will grow up around them will deprive the people of all their prosperity" - TJ
User avatar
Jason
Uber Master Poster
Uber Master Poster
Posts: 3002
Joined: Tue Feb 28, 2006 7:36 pm
Location: Snohomish, WA

Re: rifle stock rule question

Post by Jason »

I've never seen someone actually turned away from a match because of equipment. I've seen them get to shoot but not get to compete for class awards because their equipment didn't meet requirements, but I've never seen them actually not get to shoot.
Post Reply