.32 H&R Magnum / .327 Federal for Pistol Cartridge?
-
Jetmugg
- AAA Poster
- Posts: 566
- Joined: Tue Dec 06, 2005 10:10 pm
- Location: Festus, MO
Re: .32 H&R Magnum / .327 Federal for Pistol Cartridge?
No updates yet on my .327 Magnum results. The rifle is still sitting in my gun safe, unfired. I have installed a Williams rear sight, and also have a set of scope bases to be used when ammo testing at some point.
Yesterday was the first day I was able to get out to the local club to sight-in and sort out any rifles for the upcoming silhouette season which starts on March 15th.
Hopefully, yesterday was only the first of many such days. I have a couple of new rifles to sort out, and I probably spend too much time messing around with different sighting setups, trying to find the best combination of components.
Yesterday was the first day I was able to get out to the local club to sight-in and sort out any rifles for the upcoming silhouette season which starts on March 15th.
Hopefully, yesterday was only the first of many such days. I have a couple of new rifles to sort out, and I probably spend too much time messing around with different sighting setups, trying to find the best combination of components.
-
chicknsnipr60
- Unclassified Poster
- Posts: 7
- Joined: Sun Dec 07, 2014 8:31 pm
Re: .32 H&R Magnum / .327 Federal for Pistol Cartridge?
Took my 327mag out last Wednesday and was well pleased. Loaded two loads 5.0 and 5.5 titegroup.Got speeds 1655 to 1700 with no recoil. Bottomed out was shooting over chickens. Shot the pigs and was dead on with hits on top of each other on a swinger. Shot the ram with same setting and had a dead center hit. spread was 48 and had a dev of 14. Going to change front sight and put it on paper.