Page 1 of 1
cz Bottom metal?
Posted: Fri Nov 19, 2010 8:38 am
by silhouette13
morning folks,
there used to be a site to get bottom metal fro a 452 it is now closed, is there any source for decent looking metal? berhaps i should snag a pc of aluminim and a fils and make my own?
david
Re: cz Bottom metal?
Posted: Fri Nov 19, 2010 9:51 am
by saikatana
Might try here. Did not see any on main site but found this under blems;
http://www.diproductsinc.com/Detail.asp ... 1&CAT=3606
Re: cz Bottom metal?
Posted: Sat Jan 01, 2011 7:53 pm
by Sancho
David,
I've bought factory bottom metal directly from cz-USA. You just have to call them. 800 955 4486
Re: cz Bottom metal?
Posted: Sun Jan 02, 2011 12:46 am
by HotRod9mm
silhouette13 wrote:morning folks,
there used to be a site to get bottom metal fro a 452 it is now closed, is there any source for decent looking metal?...
How about this?
Or my latest: Blind Magazine(proto-type)
Re: cz Bottom metal?
Posted: Sun Jan 02, 2011 10:23 am
by BCloninger
Hot Rod, it's about time you wandered over to this corner of the net!
Re: cz Bottom metal?
Posted: Sun Jan 02, 2011 11:09 am
by HotRod9mm
BCloninger wrote:Hot Rod, it's about time you wandered over to this corner of the net!
Been here for a while(almost 2yrs) but was not able to post. Kept getting an error message so I found a work-a-round.
