Page 1 of 1

WTS Kelby Rings and bases

Posted: Thu Aug 14, 2008 9:49 am
by public safety equipment
Hello. I bought a rifle from a fellow who said if i didnt want these rings i could probably sell them here. they are by the description of mr. pearson and made by Kelby.
here is a picture of the rings on the rifle i bought.
rings and steyr/ browning A-bolt bases $70 shipped
Im new here but have 287(A+) on gunbroker.
http://www.gunbroker.com/Auction/ViewUs ... ser=280644
contact me at [email protected]
I have limited interest in trade other than maybe 4 boxs of #2200 Sierra .30 168 BTSP or 168 AMax bullets. I could also use some FED210M primers.
http://i78.photobucket.com/albums/j108/ ... 261812.jpg
http://i78.photobucket.com/albums/j108/ ... 261843.jpg

Posted: Thu Aug 14, 2008 11:24 am
by metalhead
Sorry to burst your buble but I did not make those rings. They are Kelbys that retail for abot $60.00

Marvin Pearson
Precision Target Sports, Inc.

Posted: Thu Aug 14, 2008 1:36 pm
by public safety equipment
mr. pearson. i was told they were your rings and since im not in the same circle as those who would know, i only had the info from the seller of the rifle to go by. my apologies if you are offended by the mistake.
i have altered the ad to read correctly.
http://www.gunbroker.com/Auction/ViewIt ... =106240160

Posted: Thu Aug 14, 2008 1:45 pm
by metalhead
No offense taken. How tall are they and what kind of rifle do they fit? A prospective buyer will want to know this.

Posted: Thu Aug 14, 2008 1:48 pm
by metalhead
Sorry, I should have looked at the Gunbroker add and I would have seen the rifle is a Styer....Good luck to you on your auction, Sir....M.

Posted: Thu Aug 14, 2008 1:49 pm
by public safety equipment
no sweat. bubble fully intact. hull integrity at 100% .

I just checked out sinclair and the rings are $85 and the bases $21.

so i figure these should sell quick at $70 shipped.