Tikka T1 silhouette stock, sold

[jbmarshtx]

I am selling a Tikka silhouette stock that I have had for about 2.5 years, and I used it as a backup the 2nd half of 2021. This was a MT Hunter flat top. The MT Hunter is Mark Pharr's newish design produced by McMillan. It has a XL Decelerator pad from the factory. The comb is about 0.25-0.5 below the bore line and parallel with the bore. Evelio did the intlet and bedding. It is set up for a Tikka T1x 22lr, but would probably work with a T3x IF you did some cutting on the inlet and barrel channel. The recoil lug is made from the bedding, so it is not the removable tikka.

I had the stock painted by palladin coatings in new braunfels. I am selling with the bottom metal since the inlet was done based on that. See images for measurements. The stock weighs under 3 pounds with 3 ounces of weight, bottom metal, and action screws. This stock has a heavy Pachmayr XL 1" pad on it, so you could save some weight there. With a stock tikka barreled action, bkl rings, 25x Leupold, and 3 extra ounces of weight it weighed 7#15oz.

sold

[jbmarshtx]

Additional images.

Stock bore line to comb.

Stock weight with bottom metal and screws and 3 ounces of added weight.

[jbmarshtx]

Price on stock, bottom metal dropped to $550 shipped to you. I haven't posted to rimfire central yet, but will over the weekend.

[jbmarshtx]

Trigger is sold pending funds.

[jbmarshtx]

bump with lower price. Nice set up for anyone with a tikka t1x.

[jbmarshtx]

sold