Marlin '94 CB rear sight
- PAndy
- B Poster
- Posts: 97
- Joined: Mon Jul 31, 2017 5:47 am
Marlin '94 CB rear sight
Will a Williams fp tk sight go low enough to use the factory front sight on a Marlin 1894 cowboy 24" octagon?
Could use either the 336 top mount or the side mount version, if it matters.
Thanks
Could use either the 336 top mount or the side mount version, if it matters.
Thanks
- Ojaileveraction
- A Poster
- Posts: 113
- Joined: Mon May 22, 2017 5:32 pm
- Location: Ventura California
Re: Marlin '94 CB rear sight
Correctly fitted there is no difference.
Side mount the Williams 94-36 FP/tk will not except an extended elevation screw. Leaves a lot of the sight's range untouched.
Side mount the Williams 94-36 FP/tk will not except an extended elevation screw. Leaves a lot of the sight's range untouched.
Tim
Guns, They're not really yours, until you void the warranty.
Guns, They're not really yours, until you void the warranty.
- PAndy
- B Poster
- Posts: 97
- Joined: Mon Jul 31, 2017 5:47 am
Re: Marlin '94 CB rear sight
I moved a Williams from a 94 Winchester to the Marlin and it seems to work fine. I have about seven revolutions upward on the elevation knob, if needed.
- Ojaileveraction
- A Poster
- Posts: 113
- Joined: Mon May 22, 2017 5:32 pm
- Location: Ventura California
Re: Marlin '94 CB rear sight
On a 1895cb 24 inch barrel I needed 17 turns from chickens to the rams using a 350g berry's going 1140fps MV.
Its a Marbles 1/6" bead on a .560 tall sight.
Its a Marbles 1/6" bead on a .560 tall sight.
Tim
Guns, They're not really yours, until you void the warranty.
Guns, They're not really yours, until you void the warranty.