Page 1 of 1
Sold: Willoams FP 39 for Marlin 39a
Posted: Fri May 10, 2019 8:11 am
by thauglor
Sold!!!
No longer need this one, has the grub screw so you can tighten and loosen by hand. $70 shipped, add $2 if using PayPal non gift.
PM me
20190510_065034.jpg
20190510_065041.jpg
Re: WTS: Willoams FP 39 for Marlin 39a
Posted: Fri May 10, 2019 9:12 am
by cedestech
Just a little fyi... this will fit on a 94 that is d@t for a reciever sight also. It shouldn’t max out the windage unless you have the frt sight too far over.
Re: WTS: Willoams FP 39 for Marlin 39a
Posted: Fri May 10, 2019 9:41 am
by MOTO VITA
Has the elevation screw been changed?
Do you know why the detent screws in the rear side are protruding as far as the photo shows?
Re: WTS: Willoams FP 39 for Marlin 39a
Posted: Fri May 10, 2019 1:23 pm
by thauglor
I will check when I get home, but I think it does have the longer elevation screw. The two set screws I backed out so I can freely turn the knobs without any friction so I don't break it in case I forgot to loosen them first. I use the grub screw on the elevation adjustment to stop it from moving once I get my elevation set for each animal.
Thanks cedestech, didn't know that
Re: WTS: Willoams FP 39 for Marlin 39a
Posted: Wed May 22, 2019 9:38 am
by thauglor
Btt, still for sale
Re: WTS: Willoams FP 39 for Marlin 39a
Posted: Wed May 22, 2019 10:34 am
by cedestech
I'll take it... PM to follow.