Mounting Williams Rear Peep Sight
Posted: Tue Jul 18, 2017 2:48 pm
I have a aftermarket 12" bull barrel with 6 tapped holes and would like to mount a Williams Peep Sight on it.
What is the best way to mount this?
Thinking about mounting a Picatinny Rail and drill and tap (2) 8-40 holes in it to mount the same Williams Sight That I have on my Marlin 336.
That way I could mount a scope to test loads. I have a Bond Hooded Front Sight.
Also
The rules say you cannot Extend the original sight radius by more than 1 inch
How far behind the back of the barrel can I extend the peep sight?
Thanks for any information you may have.
Larry
What is the best way to mount this?
Thinking about mounting a Picatinny Rail and drill and tap (2) 8-40 holes in it to mount the same Williams Sight That I have on my Marlin 336.
That way I could mount a scope to test loads. I have a Bond Hooded Front Sight.
Also
The rules say you cannot Extend the original sight radius by more than 1 inch
How far behind the back of the barrel can I extend the peep sight?
Thanks for any information you may have.
Larry