Need a little help

Centerfires, rimfires, pistol cartridges and everything in between.
Post Reply
dhatch
AA Poster
AA Poster
Posts: 332
Joined: Thu Jan 30, 2014 12:00 pm
Location: Jackson Parish Louisiana.
Contact:

Need a little help

Post by dhatch »

I have a M94 Win no safety, straight eject. I need a Williams rear sight. I have looked in Buffalo Arms and Midway. It isn't clear to me which one to order. I don't want to get the wrong one. Any help will be much appreciated. Thanks,
Proud Member of the C. C. S. A.
GTS
AA Poster
AA Poster
Posts: 427
Joined: Tue Nov 22, 2005 3:01 pm
Location: Little Rock, AR

Re: Need a little help

Post by GTS »

Try looking here:

http://www.williamsgunsight.com/gunsights/FPpage.htm

You should be able to sort out which one you need.
dhatch
AA Poster
AA Poster
Posts: 332
Joined: Thu Jan 30, 2014 12:00 pm
Location: Jackson Parish Louisiana.
Contact:

Re: Need a little help

Post by dhatch »

Perfect GTS, I found what I want for the M94 and I Thank You. At that site is listed sights for dovetail grooved receivers. I need one. One is for a high line of sight and the other one is for a low line. How do I measure to determine which one I have? It is a Ithaca M72 Saddle gun .22 Mag that shoots great. Any help will be appreciated.
Proud Member of the C. C. S. A.
GTS
AA Poster
AA Poster
Posts: 427
Joined: Tue Nov 22, 2005 3:01 pm
Location: Little Rock, AR

Re: Need a little help

Post by GTS »

Try looking at the info near the bottom of this page:

http://www.marblearms.com/frontSights_info.html

I think you should be able to work out which height of front sight you will need.

I just read your post again. I think I misunderstood what you were asking, but the link above may be of some help.
dhatch
AA Poster
AA Poster
Posts: 332
Joined: Thu Jan 30, 2014 12:00 pm
Location: Jackson Parish Louisiana.
Contact:

Re: Need a little help

Post by dhatch »

Thanks again GTS. I can figure it out from here.
Proud Member of the C. C. S. A.
Post Reply