Winchester 9422 trigger job
-
- AA Poster
- Posts: 270
- Joined: Sat Aug 12, 2006 11:26 am
- Location: Oro Valley, Arizona
Winchester 9422 trigger job
I was fortunate enough to pick up a pristine, unfired Winchester 9422. However the rifle would benefit from a trigger job, since the trigger is awfully creepy.
Can anyone recommend someone who can work a the trigger on this rifle to competition-level?
As usual any advice is greatly appreciated in advance!
Can anyone recommend someone who can work a the trigger on this rifle to competition-level?
As usual any advice is greatly appreciated in advance!
Joaquin B
-
- A Poster
- Posts: 145
- Joined: Mon Nov 09, 2015 7:48 pm
- Location: Fort Worth
Re: Winchester 9422 trigger job
I installed 17lb hammer springs in three different 9422's, and that gave my guns acceptable triggers. I used Wolff springs for Ruger Single Action Revolvers and cut about 1/2" off them to match the length of the original spring. The springs are very hard and I used a special heavy duty wire cutter for this job.